PRODUCTS
PRODUCT OVERVIEW
Application
EPI NEMA Type 4 Floor Mounted Enclosures are designed to house electrical controls, terminals, and instruments in areas, which may be regularly hosed down or are otherwise very wet environments.
Construction
Made from 14, 12, or 10-gauge galvanized steel. All seams are continuously welded and there are no holes or knockouts. A lip is provided around three sides of the door. This lip increases strength and keeps dirt and liquids from dropping into the enclosure. Clamps are provided on three sides of the door to ensure a watertight seal with neoprene gaskets. The gaskets are attached with an oil-resistant adhesive. All exterior hardware (such as clamps, clamp screws, hinge pins, etc.) is stainless steel. A heavy-gauge continuous stainless steel hinge supports the door. A hasp and staple are provided on the door for padlocking. Each enclosure has 12- inch floor stands.
Accessories
Panels must be ordered separately. Floor stand kits in 6, 12, 18, and 24-inch heights are available for factory installation on all NEMA 4 enclosures. Drip shield kits protect the door hardware from dripping water and settling dust.
Finish
The standard finish for enclosures is Sherwin Williams ANSI-70 light dove gray enamel inside and out. Other finishes are available for specific applications.
Industry Standard
Meets National Electrical Manufacturers Association (NEMA) standard for Type 4 (Watertight and Dust-tight) and Type 13 (Industrial use) enclosures.
Standard Sizes
Width | Height | Depth | Gauge |
---|---|---|---|
24 | 60 | 18 | 12 |
24 | 72 | 18 | 12 |
30 | 72 | 18 | 12 |
36 | 72 | 18 | 12 |
24 | 90 | 20 | 12 |
36 | 90 | 20 | 12 |
24 | 72 | 24 | 12 |
30 | 72 | 24 | 12 |
36 | 60 | 24 | 12 |
36 | 72 | 24 | 12 |
36 | 90 | 24 | 12 |
24 | 72 | 30 | 12 |
36 | 72 | 30 | 12 |
24 | 72 | 36 | 12 |
36 | 72 | 36 | 12 |
36 | 90 | 36 | 12 |