Nema Type 4 Single Door Floor Mounted Enclosures

Nema Type 4 Single Door Floor Mounted Enclosures

Application

EPI NEMA Type 4 Floor Mount Enclosures are designed to house electrical controls, terminals, and instruments in areas, which may be regularly hosed down or are otherwise very wet environments.

Construction

Made from 14, 12, or 10 gauge steel. All seams are continuously welded and there are no holes or knockouts. A lip is provided around three sides of the door. This lip increases strength and keeps dirt and liquids from dropping into the enclosure. Clamps are provided on three sides of the door to insure a watertight seal with neoprene gaskets. The gaskets are attached with oil-resistant adhesive. All exterior hardware (such as clamps, clamp screws, hinge pins, etc.) is stainless steel. A heavy gauge continuous hinge supports the door. A hasp and staple are provided on the door for padlocking. Each enclosure has 12 inch floor stands.

Finish

The standard finish for enclosures and panels is ANSI-70 light dove gray enamel inside and out. Other finishes are available for specific application.

Accessories

Panels must be ordered separately as they are not furnished. Floor stand kits in 6, 12, 18, and 24-inch heights are available for factory installation on all single door NEMA 4 enclosures. Drip shield kits protect the door hardware from dripping water and settling dust.

Standards

These enclosures meet the National Electrical Manufacturers Association (NEMA) standard for Type 4 (Industrial Use) enclosures. UL50.

Click on printer for print friendly version: Print report

Standard Sizes

Click Custom button to specify non-standard size.Custom size
WidthHeightDepthWidthHeightDepth
246018366024
247218367224
307218369024
367218247230
249020367230
369020247236
247224367236
307224369036

Item Code=3003